 |
Westell 2200 DSL Modem Advanced Setup
If you have a special network setup and
you would like to configure the Westell 2200 so it does not do Network
Address Translation or DHCP, please follow these instructions.
NOTE: Some versions of the Westell 2200 require that
the DSL phone line be plugged into the modem before you can proceed
with making this change.
- Connect a computer directly to the modem
- Reset the modem by holding the reset button (next to the ethernet
port) until the DSL light starts flashing
- Open a web browser and go to this address http://192.168.1.1
- Login with the following:
- User ID: admin
- Password: password
- Change the Administration Name and Password
- Click OK when prompted for confirmation
- Click next
- Enter the current User ID and Password from step 4
- Click next
- Click next
- Confirm that protocol is set to Bridge, click next
- Click done
- Click Configuration
- Click VC configuration
- Click the first edit button from the top
- Under VC 1 - Bridge Settings, set Mode from Routed Bridge to
Bridge, then click 'set VC'
- Click OK when prompted to Set this Bridge VC configuration
- When asked if you would like the modem to be reset now, click
OK
- The screen will indicate that the modem is reseting and will
reload
- Click Configuration, then click DHCP Configuration
- Set DHCP Server to "Off"
- Click Save
- Click OK when asked to save and reconfigure DHCP
- The 2200 should now act as if it were just a modem
- You will probably need to reboot or release and renew your DHCP
lease
The manual for the Westell 2200 can be found here...
http://www.westell.com/pages/model2200/userguide/userguide.jsp
|
|
